| ducatipaso.org http://www.ducatipaso.org/forum/ |
|
| cam belts http://www.ducatipaso.org/forum/viewtopic.php?f=4&t=1420 |
Page 1 of 2 |
| Author: | Ricardo [ Sun Oct 29, 2006 2:07 pm ] |
| Post subject: | cam belts |
| Author: | Finnpaso [ Sun Oct 29, 2006 4:25 pm ] |
| Post subject: | |
| Author: | qldman36 [ Mon Oct 30, 2006 12:16 am ] |
| Post subject: | |
| Author: | Finnpaso [ Mon Oct 30, 2006 7:49 pm ] |
| Post subject: | |
| Author: | qldman36 [ Mon Oct 30, 2006 8:32 pm ] |
| Post subject: | |
| Author: | jcslocum [ Mon Oct 30, 2006 10:10 pm ] |
| Post subject: | |
| Author: | Finnpaso [ Tue Oct 31, 2006 5:16 pm ] |
| Post subject: | |
| Author: | qldman36 [ Tue Oct 31, 2006 5:27 pm ] |
| Post subject: | |
| Author: | Finnpaso [ Tue Oct 31, 2006 8:23 pm ] |
| Post subject: | |
My screw and nut didnt coast anything, cause i steal them from my workplace! .... also that 13mm wrench! :funny: :funny: :funny: :funny: |
|
| Author: | ducapaso [ Wed Nov 01, 2006 6:50 am ] |
| Post subject: | |
| Author: | Finnpaso [ Wed Nov 01, 2006 12:48 pm ] |
| Post subject: | |
| Author: | persempre907 [ Wed Nov 01, 2006 7:31 pm ] |
| Post subject: | |
| Author: | Ricardo [ Thu Nov 02, 2006 1:21 am ] |
| Post subject: | |
Yes, can you please be more specific and provide some part numbers for both the idler as well as the tensioner bearings in the 750 Paso. What manufacturers (FAG, SKF, TIMKEN, etc.) have them available at the present time. I'm having to pay almost $25 apiece for the small FAG 630/8 that make up the idler bearing setup--and, as you know, it takes four of these little puppies to do both idlers on the two belts. Do tell!! Thanks, Ricardo PS: I apologize for having started this thread in the Classified section rather than the Technical Discussion--my bad. |
|
| Author: | Finnpaso [ Thu Nov 02, 2006 7:51 pm ] |
| Post subject: | |
| Author: | ducapaso [ Fri Nov 03, 2006 7:56 pm ] |
| Post subject: | |
| Page 1 of 2 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|