| ducatipaso.org http://www.ducatipaso.org/forum/ |
|
| Motor work? http://www.ducatipaso.org/forum/viewtopic.php?f=3&t=840 |
Page 1 of 1 |
| Author: | Rlbol [ Sun Jan 01, 2006 9:25 pm ] |
| Post subject: | Motor work? |
It is about time to rebuild my 907, 55k miles, But I was quireous as to what can be done? I would certainly not be against a big bore kit. But I really just dont know much about the 907 motor and what can be done to it. I would really like to just put an st3 engine in it. but i am not sure that is possble! Any suggestions and ideas would be greatly appreciated!! |
|
| Author: | DesmoDog [ Mon Jan 02, 2006 1:13 am ] |
| Post subject: | |
You could go with a big bore kit, or just high compression pistons if the cylinders are in decent shape. It's basically the same engine as the 900ss so most parts from that would fit. Of course you'd need a chip to go with it, but I don't think that would be a big problem. I've always wondered if a 9*6 engine would fit... |
|
| Author: | Rlbol [ Mon Jan 02, 2006 1:22 am ] |
| Post subject: | |
Thanks DesmoDog, I am assuming the worst, with the internals of the engine. That is a lot of miles! I have seen some mention of a 100HP 907 on the internet, but i have never been able to find any information about it or who built it. I certainly wouldnt mind that, but I dont need it. But would sure love for the 907 to pull like my 888 does. |
|
| Author: | DesmoDog [ Mon Jan 02, 2006 3:46 am ] |
| Post subject: | |
| Author: | Finnpaso [ Mon Jan 02, 2006 4:32 pm ] |
| Post subject: | |
| Page 1 of 1 | All times are UTC |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|