So yeh where do i start looking for this part?. I did read on another web-site that the Sprag from a KTM LC4 Motor will fit ( 640cc ?) but my local helpful Ducati / KTM Parts supplier is as about as much use as an Ash Tray on a Motorbike when i contacted him. So yeh help would be much appreciated and any thanks in advance.

G'day Harry
Have you had the engine apart to determine the condition of the sprag clutch? You may want to have a read of these web sites. You might only have to replace the spring at a fraction of the cost of a new sprag.
http://www.perthstreetbikes.com/forum/f ... tch-85481/
http://www.mad-ducati.com/Technical/Sta ... lutch.html
http://www.mad-ducati.com/Technical/Eng ... over2.html
I've had to do it to mine, just remember to wrap tape around the cams as soon as you get the sprag out.

viewtopic.php?f=1&t=4189
maybe this helps, too.

G.

Bevel Heaven also sell a sprag that they claim ( and Im sure they are right ) will fit a paso among others . I have had excelent service from them in the past

I replaced the sprag in my 907 with a 900 monster version....a couple of years ago now, but still working well.

Try Ian Gowanloch, or Gowanloch Ducati or Road & Race. There are plenty of places here in Oz that can help you out.

If you get in quick enough though, the $ is still over parity so it may be worthwhile getting one from Bevel Heaven. There are dozens of sites around that will have these.

Cheers.

Thanks for the advice everybody. I am just waiting for the Courier to drop my new Sprag off which i ended up getting from Bevel Heaven. Once it arrives it will be time to chill the Beers, break out the Spanners and start throwin them around.